The Grinding Machine




1. Part 27 is not necessarily required. It can be used to add counter weights. Weights and shaft are not in this picture.

2.

3.

4. Note the stop screws! (missing from drawings) Part 19 is secured with stop screws on both ends. Only one visible here.

5.

6.

7. Instead of of this arrangement - an offset system can be installed. Remove part 20 and change shaft to one with M35*2 at the end. And add parts in picture 7.

Part 27 is not necessarily required. It can be used to add counter weights. Weights and shaft are not in this picture.

8.

9.

10.



Copyright © 1995-2012, 2013
Juhani Kyyrö
All rights reserved
This page was last updated: